BiBi3 Plus Pet Tracker Support notes Back to manual

When the tracker goes quiet

Almost every message we get about a tracker that "stopped working" turns out to be one of four things, and none of them need a screwdriver. Work down this list before you decide the unit is faulty.

The four-minute check

  1. Does the SIM still have data? Not whether it is inserted — whether the plan is live and has balance. A prepaid card that ran out last month behaves exactly like a dead tracker: the app holds the last known position and nothing new arrives.
  2. Re-seat the card. Push it out, look at the gold contacts, slide it back until it sits flush. A card standing even a millimetre proud will break contact as the collar swings, and the fault will look intermittent.
  3. Charge it properly. Full charge, from the cable in the box, not "it switched on". A unit at five percent will boot, send one report and go back to sleep.
  4. Stand outside with it. Five minutes under open sky. Concrete walls, metal roofing and dense tree cover all cost signal, and a tag that sat indoors for a fortnight often needs a clear view before it will talk again.

If the map is still empty after those four, stop looking at the pet and start looking at the network. The next section narrows it down.

Symptom by symptom

What you seeUsual causeFirst thing to try
Nothing at all, brand-new unitSIM not activated yet, or fitted upside downWait an hour after operator activation, then re-seat the card
Position is there but hours oldEnergy-saving mode, or no data creditCheck the plan balance, then switch to live mode
Dot hops between streetsSatellite drift indoors, tower fallbackNothing — this is expected. Read the timestamp
Position updates, alerts do notPhone revoked notification permissionRe-enable notifications for the app
Went offline after a wet walkWater sitting in the contact recessDry the contacts, charge, retry
Flat by the eveningReporting interval too short for the cellTurn on energy saving between walks

A new unit that never reports

Retail SIMs are usually active by the time you get home, but not always. Some operators queue activation for up to an hour, and a card bought online can sit in a pending state until it is first used. If the app refuses to add the device at all, the problem is not the network — check the ID.

Two ID mistakes are common. The first is a leading zero that gets dropped when you type it. The second is reading the number off the small label on a curved edge and mistaking an 8 for a 0. The box is printed flat, on a bigger label, and is much easier to read from.

There is also a class of data SIM sold for IoT devices that is locked to a single access point name. If your operator gave you an APN string, it has to go into the device settings in the app. Skipping that step gives you a device that powers up, connects to nothing, and reports nothing.

A position that will not refresh

Look at the timestamp on the map before you look at anything else. The app shows the time of the last report; a position from this morning and a position from four minutes ago look identical as a dot, but they mean very different things.

If the gap is measured in tens of minutes, energy-saving mode is the obvious suspect. That mode deliberately reports less often, and a tag set to a long interval will look broken to anyone watching the screen. Switch to live mode and see whether the dot starts moving.

If the gap is measured in hours and the battery is fine, treat it as a network problem and go back to the first check. Data credit expires quietly on prepaid cards, and the app gives you no warning when it happens.

The dot wanders around

Indoors, the tag is doing its best with whatever is available. Under a roof it is usually running on WiFi and tower data, and a tower-derived position can be a street or two out. Watch a tag sitting still on a kitchen table for an afternoon and you will see the marker drift, settle, and drift again.

Outside, in the open, five metres is a fair expectation. Near tall buildings the signal bounces and the number gets worse. A wandering dot is not a fault, and no amount of re-pairing will fix it — it is the physics of the system you bought.

Alerts stopped arriving

Alerts fail on the phone far more often than on the tracker. Both major phone platforms now put unused apps to sleep, and a tracker app that has not been opened in a week is a prime candidate. Open the app once, check that notifications are still permitted, and check that the app is excluded from battery optimisation.

On the device side, two things are worth checking. The safe zone has to be saved before it will trigger, and entry and exit are separate switches. People often turn on exit alerts, then wonder why a return home produces nothing.

Finally, consider the SIM. Fence alerts travel over the mobile network like any other report. No credit means no alert, even though the app itself still works over WiFi.

After a wet walk

The housing is rated IP67, which covers rain, wet grass and a short accidental dunk. The charging contacts are the weak point, not the electronics. Water sitting in that recess will stop the unit charging long before it stops it tracking, and corroded contacts look exactly like a battery that has died.

Dry the recess with a cloth, leave the cover open somewhere warm for a few hours, then charge. If the unit still will not take a charge after that, the contacts may need cleaning with a soft pencil eraser — gently, and with the unit switched off.

Battery flat by the evening

That is a settings problem nine times out of ten, not a cell on its way out. Live tracking at a short interval will drain a 600mAh cell quickly, and a weak signal makes it worse because the tag retries. Our separate note on getting more days out of a charge covers the trade-offs in detail.

Still nothing

Then it is worth a proper look, and we will need specifics rather than a description. Device ID, the operator and country of the SIM, the app version, and the exact times when reports stopped and started. With those four we can usually tell within a couple of replies whether the unit needs replacing or the SIM needs swapping. Details on what to send are on the support page.

One thing to rule out early: a tracker that has never been paired is not broken, it is simply not connected. If the app has no device listed, start with step 4 of the manual instead.